Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSEAGLE1997VISION V6-201 3.3L VIN T SFIREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY MODULESERVICE AND REPAIR
1997 Eagle Vision V6-201 3.3L VIN T SFI
Keyless Entry Module: Service and Repair
1997 Eagle Vision V6-201 3.3L VIN T SFISECTION Service and Repair
REMOTE KEYLESS ENTRY MODULE
REMOVAL
1. Remove instrument panel top cover. The remote keyless entry module is mounted to the structural duct on the passenger side.
2. Remove the two screws attaching the receiver to the instrument panel structural duct.
3. Disconnect the two wiring connectors.
4. Replace module.
INSTALLATION
For installation, reverse the above procedures.
REMOVAL
Remote Keyless Entry (RKE) Module:
1. Remove instrument panel top cover. The remote keyless entry module is mounted to the structural duct on the passenger side.
2. Remove the two screws attaching the receiver to the instrument panel structural duct.
3. Disconnect the two wiring connectors.
4. Replace module.
INSTALLATION
For installation, reverse the above procedures.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.