Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Entering On-Board Diagnostics (Using DRB-II): Notes
1993 Eagle Talon DL, StandardSECTION Notes
- Before entering on-board diagnostics, refer to PRETEST INSPECTION . Turn ignition off. Attach Mitsubishi Motors Corporation (MMC) cartridge to DRB-II. Connect DRB-II to diagnostic connector. Diagnostic connector is located next to junction block, above left kick panel. See Figure .
- Ensure all accessories are off. Turn ignition on. All character positions will illuminate and copyright information will appear on screen for a few seconds. Display will then change to DRB-II menu.
- If DRB-II displays an error message, refer to DRB-II ERROR SCREENS. The following DRB-II modes can be accessed from DRB-II menu: VEHICLES TESTED, HOW TO USE, CONFIGURE and SELECT SYSTEM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.