Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Dynamic Damper
Dynamic damper must be properly positioned on axle shaft. Position damper so proper distance exists between damper and end of boot with axle shaft in a straight position. See Fig 1. Distance must be within specification. See DYNAMIC DAMPER INSTALLATION SPECIFICATIONS table.
| Application | (1) Damper-To-Boot End Distance | ||||||||
|---|---|---|---|---|---|---|---|---|---|
| FWD | |||||||||
| 1.8L | |||||||||
| Left (2) | 16.89-17.13 (429-435) | ||||||||
| Right (3) | 7.77-8.01 (197-203) | ||||||||
| 2.4L | |||||||||
| Left (3) | 14.25-14.49 (362-368) | ||||||||
| Right (3) | 7.72-7.96 (197-203) | ||||||||
| AWD (1.8L & 2.4L, Both Sides) (3) | 7.72-7.96 (197-203) | ||||||||
|
|||||||||
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.