Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSEAGLE1993SUMMIT WAGON DL, 1.8 CREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALGAUGESINSTRUMENT PANELREMOVAL & INSTALLATIONSPEEDOMETER CABLEINSTALLATION
1993 Eagle Summit Wagon DL, 1.8 C
Speedometer Cable: Installation
1993 Eagle Summit Wagon DL, 1.8 CSECTION Installation
- Install new cable. Insert cable until stopper seats properly in groove on rear of speedometer housing. Pull speedometer cable through firewall grommet until cable marking is visible from engine compartment.NOTE: An improperly installed cable can cause fluctuating meter, noise or damaged harness inside instrument panel.
- Install adapter onto speedometer cable (if equipped). Install instrument cluster. See INSTRUMENT CLUSTER . Install cable onto transmission or transaxle. Check for proper operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.