Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSEAGLE1992TALON TSI, FWD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - TESTS W/CODES - 2.0LCONNECTOR IDENTIFICATIONNOTES
1992 Eagle Talon TSi, FWD, Standard
Connector Identification: Notes
1992 Eagle Talon TSi, FWD, StandardSECTION Notes
CAUTION:
When battery is disconnected, vehicle computer and energy systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in the GENERAL INFORMATION Section before disconnecting battery.
CONNECTOR IDENTIFICATION DIRECTORY
| Connector | See Figure |
|---|---|
| Airflow Sensor Connector (Non-Turbo) | Figure |
| Airflow Sensor Connector (Turbo) | Figure |
| Coolant Sensor Connector | Figure |
| Crank Angle/TDC Sensor Connector | Figure |
| ECU Connectors | Figure , Figure , Figure |
| Fuel Injector Resistor Connector | Figure |
| Idle Speed Control Actuator | Figure |
| Ignition Coil Female Connector | Figure |
| Ignition Coil Male Connector | Figure |
| Inhibitor Switch Connector | Figure |
| MPI Control Relay Connector | Figure |
| Oxygen Sensor Connector | Figure |
| Power Transistor Connector | Figure |
| TPS Sensor Connector | Figure |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.