Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSEAGLE1992TALON TSI, FWD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - BASIC TESTINGIGNITION CHECKSOPTICAL IGNITION SYSTEMPOWER TRANSISTOR
1992 Eagle Talon TSi, FWD, Standard
Power Transistor
1992 Eagle Talon TSi, FWD, StandardSECTION Power Transistor
- Connect analog ohmmeter leads between power transistor terminals No. 5 and 8. See Fig 1. Ensure ohmmeter negative lead is connected to terminal No. 8. Ohmmeter should indicate no continuity.
- Using a 1.5-volt dry cell battery, connect positive battery lead to power transistor terminal No. 6 and negative lead to terminal No. 5. When battery is connected, ohmmeter should indicate continuity. Replace power transistor if it does not test as described.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.