Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSEAGLE1992TALON TSI, FWD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - BASIC TESTINGIGNITION CHECKSDIRECT IGNITION SYSTEMIGNITION COIL RESISTANCE
1992 Eagle Talon TSi, FWD, Standard
Ignition Coil Resistance
1992 Eagle Talon TSi, FWD, StandardSECTION Ignition Coil Resistance
- Disconnect ignition coil connector. Measure primary coil resistance between ignition coil terminals No. 1 and 3. Also measure resistance between ignition coil connector terminals No. 2 and 3. See Fig 1. Primary resistance should be .70-.86 ohms at 68°F (20°C).
- Measure secondary coil resistance between high voltage tower terminals for No. 1 and No. 4 cylinders. See Fig 1. Secondary resistance should be 11,300-15,300 ohms. Replace ignition coil if it does not test as described.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.