Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSEAGLE1991TALON TSI, FWD, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROLS - BASIC TESTINGFUEL SYSTEMCONTROL RELAY1.8L
1991 Eagle Talon TSi, FWD, Automatic
Control Relay: 1.8L
1991 Eagle Talon TSi, FWD, AutomaticSECTION 1.8L
- Remove control relay from vehicle. Control relay is located on right side of center console. Disconnect control relay connector. Using an ohmmeter, check for approximately 95 ohms of resistance between control relay terminals No. 3 and 5, and terminals No. 2 and 5. See Fig 1 .
- Using an ohmmeter, ensure approximately 35 ohms of resistance is present between control relay terminals No. 6 and No. 7. Ensure there is infinite resistance between terminals No. 1 and No. 4, and between terminals No. 2 and No.4.
- Connect positive ohmmeter lead to terminal No. 6 and negative lead to terminal No. 8. Ensure there is infinite resistance. Using an ohmmeter, connect positive ohmmeter lead to terminal No. 8 and negative lead to terminal No. 6. Zero ohms resistance should exist.
- While grounding terminal No. 6 and applying battery voltage to terminal No. 8, ensure there is zero ohms resistance between terminals No. 2 and 4.
- While grounding terminal No. 6 and applying battery voltage to terminal No. 7, ensure there is zero ohms resistance between terminals No. 1 and 4. Replace control relay if it does not test as described.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.