Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSEAGLE1990TALON BASE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)HEATING, VENTILATION & A/C (HVAC)GENERAL SERVICINGA/C SYSTEM GENERAL SERVICINGORIFICE TUBE R & I - 1991 PREMIERREMOVAL
1990 Eagle Talon Base, Automatic
Orifice Tube R & I - 1991 Premier: Removal
1990 Eagle Talon Base, AutomaticSECTION Removal
- The orifice tube is located in liquid refrigerant line near the condenser. Disconnect negative battery cable. Discharge A/C system using approved refrigerant recovery/recycling equipment. Using spring lock coupling clamp from A/C Kit (6125), disconnect liquid line connectors.
- Remove liquid line and insert Orifice Tube Remover (6146) into the line. Rotate orifice tube remover clockwise to engage tabs of orifice tube. See Figure . Pull orifice tube from line. Flush line thoroughly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.