Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSEAGLE1990SUMMIT BASE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSELECTRICAL COMPONENT LOCATIONSDIAGNOSTIC CONNECTOR (DLC) LOCATIONSDOMESTIC LIGHT TRUCKS & VANSCHRYSLER GROUP LLC
1990 Eagle Summit Base, Standard
CHRYSLER Group LLC
1990 Eagle Summit Base, StandardSECTION CHRYSLER Group LLC
NOTE:
This table provides a quick reference for self-diagnostic connector locations, when available from manufacturer, that ARE NOT
located at the lower left side of the dash, as mandated in 1996 by the Federal government.
CHRYSLER GROUP LLC - DOMESTIC LIGHT TRUCKS & VANS
| Application | Connector Location | |||
|---|---|---|---|---|
| Caravan, Grand Caravan, Grand Voyager, Mini Ram Van, Town & Country, & Voyager | ||||
| 1984-92 | On Left Side Fender Apron | |||
| 1993 | On Left Fender Front Fender Panel, Near SBEC | |||
| 1994-95 | On Wiring Harness, On Center Of Firewall | |||
| Dakota | ||||
| 1987-88 | On Right Side Fender Apron | |||
| 1989 | On Left Side Of Firewall | |||
| 1990-92 | On Right Side Of Firewall | |||
| 1993-95 | On Right Rear Corner Of Engine Compartment | |||
| Jeep | ||||
| Cherokee (1992-95) | On Left Front Fender Apron, Behind Air Cleaner | |||
| Comanche | On Left Front Fender Apron, Behind Air Cleaner | |||
| Grand Cherokee & Wagoneer | ||||
| 1993-95 | ||||
| PCM | On Right Rear Of Engine Compartment, Near PCM | |||
| TCM | Behind Left Side Of Instrument Panel | |||
| Wrangler (1992-95) | On Left Side Of Firewall, Near PCM | |||
| Pickup & Ramcharger | ||||
| 1985-90 | On Left Side Of Firewall | |||
| 1991-93 | On Left Front Fender Panel, Next To SBEC/PCM | |||
| 1995 Pickup | On Right Side Of Firewall | |||
| Ram Wagon & Van | ||||
| 1985-90 | On Left Side Of Firewall | |||
| 1991-95 | On Center Of Firewall, Near SBEC/PCM | |||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.