Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSEAGLE1990SUMMIT BASE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSTROUBLE SHOOTINGSYSTEM OPERATION CHECKSPEED REDUCTION SETTING
1990 Eagle Summit Base, Standard
Speed Reduction Setting
1990 Eagle Summit Base, StandardSECTION Speed Reduction Setting
- Set to the desired speed.
- Press the "SET" button. See Fig 1 .
- Check to be sure that deceleration continues while the switch is pressed, and that when it is released the constant sped at the time when it was released becomes the driving speed.
NOTE:
When the vehicle speed reaches the low limit approximately 25 MPH (40 km/h) during deceleration, the auto-cruise control will be cancelled.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.