Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSEAGLE1988PREMIER V6-182 3.0L SOHCREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINESYSTEM SPECIFICATIONSSERVICE SPECIFICATIONSCYLINDER HEAD
1988 Eagle Premier V6-182 3.0L SOHC
Cylinder Head
1988 Eagle Premier V6-182 3.0L SOHCSECTION Cylinder Head
CYLINDER HEAD
Combustion Chamber Volume 50.6 cc (3.09 cu. in.)
Valve Guide I.D. (Inside Diameter) 8.0 mm (0.315 in.)
Valve Guide O.D. (Outside Diameter) 13.0 mm (0.512 in.)
Repair Valve Guide O.D. 13.35 mm (0.526 in.)
Valve Guide Length,
Intake 45.0 mm (1.772 in.)
Exhaust 49.0 mm (1.929 in.)
Valve Seat Angle,
Intake 45°
Exhaust 45°
Flatness (Max. Warpage) (Not Resurfaceable) 0.051 mm (0.002 in.)
Head Gasket Thickness1 0.45 mm (0.057 in.)
Cylinder Head Height 110.83 mm (4.363 in.)
Combustion Chamber Volume 50.6 cc (3.09 cu. in.)
Valve Guide I.D. (Inside Diameter) 8.0 mm (0.315 in.)
Valve Guide O.D. (Outside Diameter) 13.0 mm (0.512 in.)
Repair Valve Guide O.D. 13.35 mm (0.526 in.)
Valve Guide Length,
Intake 45.0 mm (1.772 in.)
Exhaust 49.0 mm (1.929 in.)
Valve Seat Angle,
Intake 45°
Exhaust 45°
Flatness (Max. Warpage) (Not Resurfaceable) 0.051 mm (0.002 in.)
Head Gasket Thickness1 0.45 mm (0.057 in.)
Cylinder Head Height 110.83 mm (4.363 in.)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.