Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Eagle Eagle L4-151 2.5LFACTORY OEM SERVICE PROCEDURE
Oxygen Sensor: Service and Repair
1. Disconnect wire connector.
2. Remove sensor from exhaust manifold. On 4-151 engines, use tool J-29533.
3. Clean threads in manifold.
4. Coat threads in replacement sensor with an anti-seize compound and install sensor into exhaust manifold.
5. On 4-151 engines, torque sensor to 20-25 ft. lbs. using tool J-29533. On 6-258 engines, torque sensor to 31 ft. lbs.
6. Make sure that wire terminal ends are properly seated in connector, then connect wire connector.
NOTE: Do not push rubber boot down on sensor body closer than 1/2 inch from base. Also, oxygen sensor pigtail wires cannot be spliced or soldered. If broken, replace sensor.
2. Remove sensor from exhaust manifold. On 4-151 engines, use tool J-29533.
3. Clean threads in manifold.
4. Coat threads in replacement sensor with an anti-seize compound and install sensor into exhaust manifold.
5. On 4-151 engines, torque sensor to 20-25 ft. lbs. using tool J-29533. On 6-258 engines, torque sensor to 31 ft. lbs.
6. Make sure that wire terminal ends are properly seated in connector, then connect wire connector.
NOTE: Do not push rubber boot down on sensor body closer than 1/2 inch from base. Also, oxygen sensor pigtail wires cannot be spliced or soldered. If broken, replace sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
