1982 Eagle Eagle L4-151 2.5LFACTORY OEM SERVICE PROCEDURE

Toe Adjustment


To adjust toe-in, loosen the clamps at both ends of the adjustable tubes on each tie rod. Turn the tubes an equal amount until the toe-in is correct. Turning the right tube in the direction the wheels revolve when the car is going forward increases the toe-in and turning the left tube in the opposite direction increases toe-in. To decrease toe-in turn the right tube backward and the left tube forward. It is important that both tubes be turned an equal amount in order to maintain the correct position of the steering wheel. When adjustment is complete, tighten all clamp bolts.
In performing service operations on the steering linkage or when adjusting toe-in, be sure to square the tie rod ball sockets on the studs and align the tie rod stud in the center, or slightly above center, of the cross tube opening, before tightening the steering linkage adjusting tube. This will prevent the stud from contacting the side of the cross tube opening, which would otherwise result in noise problems or damage.



Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.