Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Eagle Eagle L4-151 2.5LFACTORY OEM SERVICE PROCEDURE
Cruise Control Switch: Service and Repair
1. Remove lower steering column cover and disconnect four-wire connector. On tilt column, remove wires from connector and tape two wires back along harness. Tape string to wire harness. On standard column, tape string to connector.
2. Pull control switch assembly straight out and remove from headlamp switch. Pull wiring harness slowly up through and out of steering column.
3. Reverse procedure to install. On tilt columns, route harness through opening in left side of steering shaft.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
