Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Section 4 (Battery System (Service Information)): Cleaning
The following information details the recommended cleaning procedures for the battery and related components. In addition to the maintenance schedules found in this service information and the owner manual, it is recommended that these procedures be performed any time the battery or related components must be removed for vehicle service.
- Clean the battery cable terminal clamps of all corrosion. Remove any corrosion using a wire brush or a post and terminal cleaning tool, and a sodium bicarbonate (baking soda) and warm water cleaning solution.
1 - Terminal Cleaning Tool 2 - Battery Cable Terminal Clamp - Clean the battery tray and battery hold-down hardware of all corrosion. Remove any corrosion using a brush and a sodium bicarbonate (baking soda) and warm water cleaning solution. Paint any exposed bare metal.
1 - Stiff Bristle Parts Cleaning Brush 2 - Warm Water Cleaning Solution 3 - Battery Case - If the removed battery is to be reinstalled, clean the outside of the battery case and the top cover with a sodium bicarbonate (baking soda) and warm water cleaning solution using a stiff bristle parts cleaning brush to remove any acid film. Rinse the battery with clean water. Ensure that the cleaning solution does not enter the battery cells through the vent holes. If the battery is being replaced, Refer to BATTERY SPECIFICATIONS for the factory-installed battery specifications . Confirm that the replacement battery is the correct size and has the correct ratings for the vehicle.
- Clean the battery thermal guard with a sodium bicarbonate (baking soda) and warm water cleaning solution using a stiff bristle parts cleaning brush to remove any acid film.
- Clean any corrosion from the battery terminal posts with a wire brush or a post and terminal cleaner, and a sodium bicarbonate (baking soda) and warm water cleaning solution.
1 - Terminal Cleaner 2 - Battery Cable Terminal Clamp 3 - Battery
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.