SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024PROMASTER 3500 BASE, CUTAWAYREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3 (AXLE SHAFTS)REMOVAL AND INSTALLATIONRIGHT HALFSHAFT(HALFSHAFT TORQUE SPECIFICATIONS)
2024 Dodge and Ram ProMaster 3500 Base, Cutaway

(HALFSHAFT Torque Specifications)

2024 Dodge and Ram ProMaster 3500 Base, CutawaySECTION (HALFSHAFT Torque Specifications)
WARNING: This page is about a different car, the 2024 RAM ProMaster EV. However, it is still accessible from the selected car via links, so may be relevant.
GC0224431Courtesy of CHRYSLER GROUP, LLC
CALLOUT DESCRIPTION SPECIFICATION COMMENT
1 Hub Nut Torque Procedure: 
  1. Install NEW hub nut. 
  2. Tighten hub nut to 150 N.m + 35° (110 Ft. Lbs. + 35°) 
    NOTE:

    Do not use air tools on staking tool while staking hub nut. 

    RENDER: 1.0x

    NO RELATED

    Recommended Tools & Savings

    Use the Manual With the Right Hardware

    Pair factory procedures with proven DIY tools so the instructions are easier to execute.

    Affiliate disclosure: We may earn a commission at no extra cost to you.

    Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

    When to See a Mechanic

    Stop DIY work and contact a certified mechanic immediately if any of the following apply:

    • • You smell fuel, burning insulation, or see smoke.
    • • Brakes feel soft, pull hard to one side, or make grinding noises.
    • • The engine overheats, stalls repeatedly, or misfires under load.
    • • You are missing required tools, torque specs, or safe lifting equipment.
    • • You are not confident in the next step or safety outcome.