Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024PROMASTER 3500 BASE, CUTAWAYREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1 (ELECTRIFIED POWERTRAIN SYSTEM (2 OF 2))
2024 Dodge and Ram ProMaster 3500 Base, Cutaway
Section 1 (Electrified Powertrain System (2 Of 2))
2024 Dodge and Ram ProMaster 3500 Base, CutawaySECTION Section 1 (Electrified Powertrain System (2 Of 2))
WARNING: This page is about a different car, the 2024 RAM ProMaster EV. However, it is still accessible from the selected car via links, so may be relevant.
- High Voltage Battery
- Description And Operation
- BEV High Voltage Battery
- Notes
- Description And Operation - High Voltage Battery
- Functional Description - Battery Pack Control Module (BPCM)
- Functional Description - Electric Vehicle Control Unit (EVCU)
- Functional Description - HVIL Circuit
- Functional Description - Instrument Panel Cluster (IPC)
- Functional Description - Power Inverter Module (PIM)
- Technical Data - System Architecture
- Battery Electric Vehicle (BEV) Charging
- BEV High Voltage Battery
- Standard Procedure
- BEV Vehicle Pushing Procedure
- High Voltage Safety Procedures
- MULTIMETER Setup For High Voltage Check
- Vehicle High Voltage Power Down
- High Voltage Power Up
- Internal HV Battery Module Isolation - Safe Mode
- Internal HV Battery Bus Bar Installation And Voltage Stack Up
- High Voltage Loss Of Isolation Test Procedure
- Pressure Testing The Battery Case And HV Battery Cooling System
- Resolver Relearn
- Specifications
- High Voltage Battery
- Cables
- Removal And Installation
- High Voltage Power Distribution Center (HVPDC) To Integrated Dual Charging Module (IDCM)
- Charge Port To High Voltage Battery Pack
- Charge Port Jumper Harness
- Battery Pack To Electric Drive Motor (EDM)
- High Voltage Power Distribution Center (HVPDC) To Electronic Air Conditioning Compressor (EAC)
- High Voltage Power Distribution Center (HVPDC) To Battery Coolant Heater (BCH)
- High Voltage Power Distribution Center (HVPDC) To Electric Cabin Heater (ECH)
- Removal And Installation
- Fuses
- Description And Operation
- Battery Cooling
- Park System
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.