Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024PROMASTER 3500 BASE, CUTAWAYREPAIR AND DIAGNOSISELECTRICALMOTORS, SWITCHES, RELAYSPOWER DISTRIBUTIONMODULE, WIRELESS CHARGING PADREMOVAL AND INSTALLATIONWIRELESS CHARGING PAD MODULE
2024 Dodge and Ram ProMaster 3500 Base, Cutaway
Wireless Charging Pad Module
2024 Dodge and Ram ProMaster 3500 Base, CutawaySECTION Wireless Charging Pad Module
REMOVAL
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the Instrument panel cupholder. Refer to CUPHOLDER, INSTRUMENT PANEL, REMOVAL AND INSTALLATION .
- Remove the fasteners that secure the wireless charging pad module to the instrument panel cupholder.
1 - Instrument Panel Cupholder 2 - Fasteners 3 - Wireless Charging Pad Module - Remove the wireless charging pad module.
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- Install the fasteners and tighten securely.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.