Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024PROMASTER 3500 BASE, CUTAWAYREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASDRIVER ASSISTANCE - SYSTEM COMPONENTSMODULESREMOVAL AND INSTALLATIONPARK ASSIST MODULE (PAM) 2
2024 Dodge and Ram ProMaster 3500 Base, Cutaway
Park Assist Module (PAM) 2
2024 Dodge and Ram ProMaster 3500 Base, CutawaySECTION Park Assist Module (PAM) 2
REMOVAL
- Remove the Body Control Module (BCM). Refer to MODULE, BODY CONTROL (BCM), REMOVAL AND INSTALLATION .
- Remove the fasteners securing the PAM to the instrument panel.
1 - PAM 2 - Fasteners - Disconnect the wire harness connectors from the PAM then remove the module from the vehicle.
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- Tighten the fasteners securely.
- Using the diagnostic scan tool, perform the surround view camera programming. Refer to PROGRAMMING AND CALIBRATION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.