Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024PROMASTER 3500 BASE, CUTAWAYREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTENTERTAINMENT SYSTEMS(DISPLAY SCREEN MODULE (DSM) - ELECTRICAL DIAGNOSTICS)
2024 Dodge and Ram ProMaster 3500 Base, Cutaway
(Display Screen Module (DSM) - Electrical Diagnostics)
2024 Dodge and Ram ProMaster 3500 Base, CutawaySECTION (Display Screen Module (DSM) - Electrical Diagnostics)
- Diagnostic Code Index
- DTC Troubleshooting
- B142A-4B Ecu Unit High Temperature - Over Temperature
- B157E-00 Touch Screen Locked - No Subtype Information
- B157E-01 Touch Screen Locked - General Electrical Failure
- B210A-16 System Voltage - Circuit Voltage Below Threshold
- B210A-17 System Voltage - Circuit Voltage Above Threshold
- B2206-00 Current VIN Missing Mismatch - No Subtype Information
- B221E-00 Ecu Internal Error - No Subtype Information
- U0010-00 BH Can Interior Bus - No Subtype Information
- U0011-00 BH Can Bus Off Performance - No Subtype Information
- U0140-87 Lost Communication With Body Control Module-Missing Message
- U0140-8F Lost Communication With Body Control Module - Erratic
- U0151-00 Lost Communication With Cluster CCN - No Subtype Information
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.