Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024PROMASTER 3500 BASE, CUTAWAYREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASPARK ASSIST MODULE (PAM) (PTS/PAM) - DTCS C100C-29 TO U1700-86
2024 Dodge and Ram ProMaster 3500 Base, Cutaway
Park Assist Module (PAM) (PTS/PAM) - DTCS C100C-29 To U1700-86
2024 Dodge and Ram ProMaster 3500 Base, CutawaySECTION Park Assist Module (PAM) (PTS/PAM) - DTCS C100C-29 To U1700-86
- DTC Troubleshooting
- C100C-29 Sensor Rear Internal Left - Signal Invalid
- C100D-12 Sensor Rear Internal Right - Circuit Short To Battery
- C100D-14 Sensor Rear Internal Right - Circuit Short To Ground Or Open
- C100D-29 Sensor Rear Internal Right - Signal Invalid
- C100E-12 Sensor Rear Outer Right - Circuit Short To Battery
- C100E-14 Sensor Rear Outer Right - Circuit Short To Ground Or Open
- C100E-29 Sensor Rear Outer Right - Signal Invalid
- C1013-12 PARKFIT Sensor Front Left - Circuit Short To Battery
- B0126-54 Calibration Missing - Missing Calibration
- C1013-29 PARKFIT Sensor Front Left - Signal Invalid
- C1014-12 PARKFIT Sensor Front Right - Circuit Short To Battery
- C1014-14 PARKFIT Sensor Front Right - Circuit Short To Ground Or Open
- C1014-29 PARKFIT Sensor Front Right - Signal Invalid
- C1015-12 PARKFIT Sensor Rear Left - Circuit Short To Battery
- C1015-14 PARKFIT Sensor Rear Left - Circuit Short To Ground Or Open
- C1015-29 PARKFIT Sensor Rear Left - Signal Invalid
- C1016-12 PARKFIT Sensor Rear Right - Circuit Short To Battery
- C1016-14 PARKFIT Sensor Rear Right - Circuit Short To Ground Or Open
- C1016-29 PARKFIT Sensor Rear Right - Signal Invalid
- C1017-17 Sensor Power Supply - Circuit Voltage Above Threshold
- C1017-1C Sensor Power Supply - Circuit Voltage Out Of Range
- C1018-42 Ecu General Memory Failure
- U1001-87 C2 Can - Missing Message
- U1001-88 C2 Can - Bus Off
- U1700-24 BCM Body Computer Module - Signal Stuck High
- U1700-29 BCM Body Computer Module-Signal Invalid
- U1700-35 BCM Body Computer Module - Signal High Time Maximum
- U1700-86 BCM Body Computer Module - Signal Invalid
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.