Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024DURANGO SXT PLUS, RWDREPAIR AND DIAGNOSISQUICK LOOKUPSDTC INDEXDTC INDEX (1 OF 2)MODULE, ELECTRONIC SHIFT (ESM), 8HP95
2024 Dodge and Ram Durango SXT Plus, RWD
Module, Electronic Shift (ESM), 8HP95
2024 Dodge and Ram Durango SXT Plus, RWDSECTION Module, Electronic Shift (ESM), 8HP95
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| B2204-00 | ECU CONFIGURATION MISMATCH |
| B223B-00 | VEHICLE CONFIGURATION MISMATCH |
| P0607-00 | ECU INTERNAL PERFORMANCE - ESM |
| P0814-00 | TRANSMISSION RANGE DISPLAY CIRCUIT |
| P0820-00 | GEAR LEVER X-Y POSITION SENSOR CIRCUIT |
| P0930-00 | BTSI CONTROL CIRCUIT LOW |
| P0931-00 | BTSI CONTROL CIRCUIT HIGH |
| P1C86-14 | PRNDL DISPLAY - CIRCUIT SHORT TO GROUND OR OPEN |
| P1C8B-16 | BATTERY VOLTAGE - CIRCUIT VOLTAGE BELOW THRESHOLD |
| P1C8B-17 | BATTERY VOLTAGE - CIRCUIT VOLTAGE ABOVE THRESHOLD |
| P1C8C-16 | SYSTEM VOLTAGE - CIRCUIT VOLTAGE BELOW THRESHOLD |
| P1C8C-17 | SYSTEM VOLTAGE - CIRCUIT VOLTAGE ABOVE THRESHOLD |
| U0001-00 | CAN C BUS |
| U0002-00 | CAN C BUS OFF PERFORMANCE |
| U0074-00 | DEDICATED POWERTRAIN (D-PT) CAN BUS OFF |
| U0101-00 | LOST COMMUNICATION WITH TCM |
| U0140-00 | LOST COMMUNICATION WITH BODY CONTROL MODULE |
| U0402-00 | INVALID DATA RECEIVED FROM TCM |
| U0422-00 | IMPLAUSIBLE DATA RECEIVED FROM BODY CONTROL MODULE |
| U114C-00 | LOST COMMUNICATION WITH PRNDL DISPLAY |
| U11C3-00 | ESM LOST COMMUNICATION WITH TCM ON D-PT CAN |
| U145D-00 | IMPLAUSIBLE DATA RECEIVED FROM TCM ON D-PT |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.