Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSDODGE AND RAM2024DURANGO SXT PLUS, RWDREPAIR AND DIAGNOSISENGINE PERFORMANCEIGNITION SYSTEM (SERVICE INFORMATION)SENSOR, KNOCKREMOVAL6.4LRIGHT SIDE

2024 Dodge and Ram Durango SXT Plus, RWD

Right Side

2024 Dodge and Ram Durango SXT Plus, RWDSECTION Right Side

Raise and support the vehicle.
Remove the knock sensor heat shield.

Courtesy of CHRYSLER GROUP, LLC
Disconnect the knock sensor (1) wire harness connector (5).
Remove the knock sensor retaining bolt (2).
Remove the knock sensor from the cylinder block.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.