Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024DURANGO SRT HELLCAT PLUSREPAIR AND DIAGNOSISTRANSMISSIONTRANSFER CASEDRIVETRAIN CONTROL MODULE (DTCM) - DTCS C1415-92 TO C230A-11
2024 Dodge and Ram Durango SRT Hellcat Plus
Drivetrain Control Module (DTCM) - DTCS C1415-92 To C230A-11
2024 Dodge and Ram Durango SRT Hellcat PlusSECTION Drivetrain Control Module (DTCM) - DTCS C1415-92 To C230A-11
- DTC Troubleshooting
- C1415-92 Transfer Case Motor Current - Performance Or Incorrect Operation
- C1438-00 Transfer Case Differential Clutch Worn
- C1444-00 Transfer Case Motor Overuse
- C1472-92 Transfer Case Clutch Control - Performance Or Incorrect Operation
- C1476-00 Transfer Case Clutch Position Out Of Range
- C1477-4B Transfer Case Clutch - Over Temperature
- C2108-11 Drivetrain Supply Voltage - Circuit Short To Ground
- C2110-11 Sensor Supply 1 Voltage - Circuit Short To Ground
- C2110-12 Sensor Supply 1 Voltage - Circuit Short To Battery
- C2129-16 Battery Voltage - Circuit Voltage Below Threshold
- C2129-17 Battery Voltage - Circuit Voltage Above Threshold
- C2201-00 FDCM/DTCM Internal
- C2206-00 Vehicle Configuration Mismatch
- C2221-00 ELSD DTC Present
- C230A-11 Neutral Indicator Control Circuit Low
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.