Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024DURANGO SRT HELLCAT PLUSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 8 (6.4L FUEL SYSTEM)FUEL INJECTION, GASTHROTTLE BODYINSTALLATION6.4L
2024 Dodge and Ram Durango SRT Hellcat Plus
Throttle Body: Installation: 6.4L
2024 Dodge and Ram Durango SRT Hellcat PlusSECTION 6.4L
WARNING: This page is about a different variant/trim than selected.
- Clean and inspect the throttle body-to-intake manifold rubber O-Ring seal (1) and replace if necessary.
- Clean the sealing surface of throttle body and intake manifold (2).CAUTION:
Do not use spray (carb) cleaners on any part of the throttle body. Do not apply silicone lubricants to any part of the throttle body.
- Install the throttle body (1). Tighten bolts (3) to the proper specifications. Refer to: FUEL INJECTION, TORQUE SPECIFICATIONS .
- Connect the throttle body wire harness connector (2).
- Install the air cleaner housing. Refer to: 6.4L, BODY, AIR CLEANER, INSTALLATION .
- Connect the negative battery cable.
- A scan tool may be used to learn electrical parameters. Go to the Miscellaneous menu and then select ETC Relearn. If the relearn is not performed, a Diagnostic Trouble Code (DTC) will be set. If necessary, use a scan tool to erase any DTCs from the PCM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.