SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024DURANGO SRT HELLCAT PLUSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 7 (5.7L FUEL SYSTEM)FUEL INJECTION, GASTHROTTLE BODYINSTALLATION5.7L
2024 Dodge and Ram Durango SRT Hellcat Plus

Throttle Body: Installation: 5.7L

2024 Dodge and Ram Durango SRT Hellcat PlusSECTION 5.7L
WARNING: This page is about a different variant/trim than selected.
  1. Clean and check condition of the throttle body-to-intake manifold O-Ring (2), replace if necessary.
    GC0209296Courtesy of CHRYSLER GROUP, LLC
  2. Clean the mating surfaces of the throttle body and intake manifold.
  3. Install the throttle body to intake manifold by positioning throttle body to manifold alignment pins.
  4. Install the throttle body mounting bolts finger tight.
    CAUTION:

    The throttle body mounting bolts MUST be tightened to specifications. Over tightening can cause damage to the throttle body or the intake manifold.

  5. Using the sequence shown in illustration, tighten the retaining bolts to 6 N.m (53 in. lbs.).
    Fig 1: Throttle Body Tightening Sequence
    GC0209295Courtesy of CHRYSLER GROUP, LLC
  6. Connect the electrical connector (3).
    GC0209297Courtesy of CHRYSLER GROUP, LLC
  7. Position the resonator onto the throttle body and air cleaner housing.
    GC0209345Courtesy of CHRYSLER GROUP, LLC
  8. Tighten the hose clamp at the throttle body (4) to 5 N.m (45 in. lbs.).
  9. Install the resonator retaining bolt (3) and tighten to 5 N.m (45 in. lbs.).
  10. Tighten the hose clamp at the air cleaner housing (2) to 5 N.m (45 in. lbs.).
  11. Connect the electrical connector at the Intake Air Temperature (IAT) sensor (1).
    GC0209731Courtesy of CHRYSLER GROUP, LLC
  12. Install the engine cover (2).
  13. Install the oil fill cap (1).
    GC0208685Courtesy of CHRYSLER GROUP, LLC
  14. Connect the negative battery cable (2).
  15. Using the diagnostic scan tool, perform the ETC Relearn function.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.