Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024DURANGO SRT HELLCAT PLUSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 6 (3.6L FUEL SYSTEM)FUEL DELIVERY, GASSENDING UNIT AND SENSOR, FUEL LEVELINSTALLATION
2024 Dodge and Ram Durango SRT Hellcat Plus
Sending Unit And Sensor, Fuel Level: Installation
2024 Dodge and Ram Durango SRT Hellcat PlusSECTION Installation
WARNING: This page is about a different variant/trim than selected.
- Position the fuel level sending unit to the fuel pump module, slide unit on mounting track until the plastic locking tab (3) snaps into position.
- Route the fuel level sending unit wires into the retaining tabs (1, 2) on the fuel pump module.
- Connect the fuel level sending unit wire harness connectors (1, 2) to the fuel pump module.
- Install the main fuel pump module. Refer to: MAIN FUEL PUMP MODULE .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.