Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024DURANGO SRT HELLCAT PLUSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 4 (3.6L ENGINE (SERVICE INFORMATION) (2 OF 2))ENGINE MOUNTINGINSULATOR, ENGINE MOUNT, RIGHTREMOVAL
2024 Dodge and Ram Durango SRT Hellcat Plus
Insulator, Engine Mount, Right: Removal
2024 Dodge and Ram Durango SRT Hellcat PlusSECTION Removal
WARNING: This page is about a different variant/trim than selected.
- Disconnect and isolate the negative battery cable.
- Remove the cowl extension silencer. Refer to SILENCER, COWL EXTENSION, REMOVAL .
- Remove the bolts (1) and the engine mount heat shield from both the left and right engine mounts.
- Remove both the left and right engine mount nuts (1).
- Place a high stand under the oil pan and lift the engine off the engine mount isolator stud.
- Remove the two bolts (1) from the right engine mount isolator.
- Remove the right engine mount isolator from the vehicle.
- If required, remove the four bolts from the right engine mount bracket and remove the bracket from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.