Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024DURANGO SRT HELLCAT PLUSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 4 (3.6L ENGINE (SERVICE INFORMATION) (2 OF 2))ENGINE BLOCKDAMPER, VIBRATIONREMOVAL
2024 Dodge and Ram Durango SRT Hellcat Plus
Damper, Vibration: Removal
2024 Dodge and Ram Durango SRT Hellcat PlusSECTION Removal
WARNING: This page is about a different variant/trim than selected.
- Remove the accessory drive belt. Refer to: 3.6L BELT, SERPENTINE, REMOVAL
.NOTE:
A force greater than 350 N. m (260 ft. lbs.) may be required to remove the crankshaft vibration damper bolt.
- Hold the crankshaft vibration damper (1) with the special tool # 10198, (Vibration Damper Holder) (2) and remove the crankshaft vibration damper bolt.
- Pull the crankshaft vibration damper (1) from the crankshaft.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.