Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024DURANGO SRT HELLCAT PLUSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 3 (COOLING SYSTEM [3.6L, 5.7L, 6.4L])ENGINEHEATER, ENGINE BLOCKINSTALLATION3.6L
2024 Dodge and Ram Durango SRT Hellcat Plus
Heater, Engine Block: Installation: 3.6L
2024 Dodge and Ram Durango SRT Hellcat PlusSECTION 3.6L
WARNING: This page is about a different variant/trim than selected.
- Thoroughly clean the cylinder block heater cavity and seat.
- Install the block heater (1) and tighten the fastener (2) to the proper specifications. Refer to : TORQUE SPECIFICATIONS GAS .
- Attach the power cord plug to the block heater.
- Fill the cooling system to the proper level. Refer to: cooling system, STANDARD PROCEDURE .
- Install the A/C compressor. Refer to: 3.6L ENGINE, COMPRESSOR, A/C, INSTALLATION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.