Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024DURANGO SRT HELLCAT PLUSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 2 (6.4L ENGINE (SERVICE INFORMATION))VALVE TIMINGPHASER, CAMSHAFTINSTALLATION
2024 Dodge and Ram Durango SRT Hellcat Plus
Phaser, Camshaft: Installation
2024 Dodge and Ram Durango SRT Hellcat PlusSECTION Installation
WARNING: This page is about a different variant/trim than selected.
CAUTION:
This is a Zero-Tolerance engine. Failure to properly align the timing chain to the timing gears will cause severe engine damage. It is imperative that the Timing Marks shown in the subsequent steps be properly aligned during assembly.
- Lift upwards on the timing chain (1) and install the camshaft phaser to the camshaft.
- The timing mark located on the camshaft phaser must be properly centered between the dual marks on the timing chain while at the 12 O'clock position (1).
- Install the camshaft phaser retaining bolt (1) and tighten finger tight.
- Install the timing chain tensioner. Refer to TENSIONER, ENGINE TIMING, INSTALLATION .
- Tighten the camshaft phaser bolt to the proper specifications. Refer to: TORQUE SPECIFICATIONS .
- Verify that the chains are operating smoothly. The chain must be replaced if:
- Any kinks
- Signs of binding
- Damage to the links
- Signs of wear or stretching
- Install the timing cover. Refer to COVER(S), ENGINE TIMING, INSTALLATION .
- Connect the negative battery cable.
- Start the engine and inspect for leaks.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.