Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024DURANGO SRT HELLCAT PLUSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 19 ((ELECTRONIC SHIFT MODULE (ESM) - ELECTRICAL DIAGNOSTICS - 8HP70 AUTOMATIC TRANSMISSION))
2024 Dodge and Ram Durango SRT Hellcat Plus
Section 19 ((Electronic Shift Module (ESM) - Electrical Diagnostics - 8HP70 Automatic Transmission))
2024 Dodge and Ram Durango SRT Hellcat PlusSECTION Section 19 ((Electronic Shift Module (ESM) - Electrical Diagnostics - 8HP70 Automatic Transmission))
WARNING: This page is about a different variant/trim than selected.
- Diagnostic Code Index
- DTC Troubleshooting
- B2204-00 Ecu Configuration Mismatch
- P0607-00 Ecu Internal Performance - ESM
- P0814-00 Transmission Range Display Circuit
- P0919-00 Gear Shift Position Control Error
- P0928-00 BTSI Control
- P1C86-14 PRNDL Display - Circuit Short To Ground Or Open
- P1C8B-16 Battery Voltage - Circuit Voltage Below Threshold
- P1C8B-17 Battery Voltage - Circuit Voltage Above Threshold
- P1C8C-16 System Voltage - Circuit Voltage Below Threshold
- P1C8C-17 System Voltage - Circuit Voltage Above Threshold
- U0002-00 Can C Bus Off Performance
- U0074-00 Dedicated Powertrain (D-Pt) Can Bus Off
- U0100-00 Lost Communication With ECM/Pcm
- U0101-00 Lost Communication With TCM
- U0140-00 Lost Communication With Body Control Module
- U145D-00 Implausible Data Received From TCM On D-Pt
- U0146-00 Lost Communication With Central Gateway
- U0155-00 Lost Communication With Cluster/CCN
- U0402-00 Implausible Data Received From TCM
- U114C-00 Lost Communication With PRNDL Display
- U1175-00 Lost Ignition Status Message
- U11C3-00 ESM Lost Communication With TCM On D-Pt Can
- Standard Procedure
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.