Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024DURANGO SRT HELLCAT PLUSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 12 (3.6L EMISSIONS CONTROL)EXHAUST GAS RECIRCULATIONSENSOR, EGR TEMPERATUREINSTALLATION
2024 Dodge and Ram Durango SRT Hellcat Plus
Sensor, EGR Temperature: Installation
2024 Dodge and Ram Durango SRT Hellcat PlusSECTION Installation
WARNING: This page is about a different variant/trim than selected.
- Clean the EGR temperature sensor sealing surface.
- Install EGR temperature sensor (1) and tighten to the proper specifications. Refer to EXHAUST GAS RECIRCULATION, TECHNICAL SPECIFICATIONS .
- Connect EGR temperature sensor wire harness connector (1).
- Connect the negative battery cable.
- Install the engine cover. Refer to 3.6L, COVER, ENGINE, INSTALLATION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.