Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024DURANGO SRT HELLCAT PLUSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 102 (8HP50/850RE AUTOMATIC TRANSMISSION - DTCS P1DC9-00 TO U0104-00)
2024 Dodge and Ram Durango SRT Hellcat Plus
Section 102 (8HP50/850RE Automatic Transmission - DTCS P1DC9-00 To U0104-00)
2024 Dodge and Ram Durango SRT Hellcat PlusSECTION Section 102 (8HP50/850RE Automatic Transmission - DTCS P1DC9-00 To U0104-00)
WARNING: This page is about a different variant/trim than selected.
- DTC Troubleshooting
- P1DC9-00 Clutch Temp Threshold Achieved Skip Shift Down Inhibit
- P1DCA-00 Park Sense Circuit Open
- P1DCD-00 TCM Monitoring Processor Performance Multiple Clutches Locked Up
- P1DCE-00 TCM Monitoring Processor Performance Incorrect Driving Direction
- P1DCF-00 TCM Monitoring Processor Performance UNALLOWED Park Engagement Due To Abs Failure
- P1DD0-00 TCM Monitoring Processor Performance UNALLOWED Park Engagement
- P1DD1-00 Input-Turbine Speed Sensor 1 Gradient Fault
- P1DD2-00 Torque Request Signal From TCM Denied
- P1DDC-00 TCM Monitoring Processor Performance UNALLOWED Reverse Engagement
- P1DDD-00 TCM Monitoring Performance Unable To Disengage Drive Or Reverse
- P1DDE-00 Ignition Run-Start Input 1-2 Correlation
- P1DEB-00 Incorrect Gear Displayed Due To Incorrect Gear Ratio
- P1DF3-00 Ecu Not Initialized
- P1DF7-00 Actual Decrease Of Engine Torque Low
- P1DF8-00 Actual Decrease Of Engine Torque High
- P1DF9-00 Actual Increase Of Engine Torque Low
- P1DFA-00 Actual Increase Of Engine Torque High
- P215C-00 Output Shaft Speed Wheel Speed Correlation
- P2761-00 Torque Converter Clutch Pressure Control Solenoid Control Circuit-Open
- P2762-00 Torque Converter Clutch Pressure Control Solenoid Control Circuit Range-Performance
- P2763-00 Torque Converter Clutch Pressure Control Solenoid Control Circuit High
- P2764-00 Torque Converter Clutch Pressure Control Solenoid Control Circuit Low
- U0001-00 Can C Bus
- U0074-00 Dedicated Powertrain (Dpt) Can Bus Off
- U0100-00 Lost Communication With ECM/Pcm
- U0102 Lost Communication With Transfer Case Control Module
- U0103-00 Lost Communication With Electric Gear Shift Module
- U0104-00 Lost Communication With Cruise Control Module
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.