Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024DURANGO SRT HELLCAT PLUSREPAIR AND DIAGNOSISENGINE PERFORMANCETUNE-UPIGNITION SYSTEM (SERVICE INFORMATION)COIL, IGNITIONREMOVAL5.7L/6.4L
2024 Dodge and Ram Durango SRT Hellcat Plus
Coil, Ignition: Removal: 5.7L/6.4L
2024 Dodge and Ram Durango SRT Hellcat PlusSECTION 5.7L/6.4L
- Disconnect and isolate the negative battery cable.
- Remove the engine cover.
- Disconnect the wire harness connector (1) from the coil (3).
- Clean the area at the base of the coil with compressed air before removal.NOTE:
The ignition coil mounting bolts are retained in the ignition coil.
- Remove the ignition coil mounting bolts (2).
- Carefully pull up the ignition coil (1) to removed it from the cylinder head cover.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.