Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024DURANGO SRT HELLCAT PLUSREPAIR AND DIAGNOSISBODY & FRAMEFRAMES, SUBFRAMES & CROSSMEMBERSFRAME AND BUMPERSTECHNICAL SPECIFICATIONSTORQUE SPECIFICATIONS
2024 Dodge and Ram Durango SRT Hellcat Plus
Torque Specifications
2024 Dodge and Ram Durango SRT Hellcat PlusSECTION Torque Specifications
| DESCRIPTION | N. m | Ft Lbs | In Lbs | COMMENT |
|---|---|---|---|---|
| Engine cradle crossmember support bolts | 180 | 133 | - | |
| Engine cradle stiffener bracket bolts | 20 | 15 | - | |
| Front bumper beam inner bolts | 26 | 19 | - | |
| Front bumper beam outer bolts | 9 | - | 80 | |
| Front hub nuts | 310 | 229 | - | |
| Front driveshaft bolts | 32 | 24 | - | |
| Front skid plate bolts | 25 | 18 | - | |
| Front suspension skid plate bolts | 25 | 18 | - | |
| Front tow hook bolts | 47 | 35 | - | |
| Front tow hook support bracket bolts | 47 | 35 | - | |
| Front tow hook nuts | 25 | 18 | - | |
| Fuel tank skid plate nuts | 28 | 21 | - | |
| Rear bumper support bolts | 54 | 40 | - | |
| Rear mass damper to rear cradle | 61 | 45 | - | |
| Rear suspension crossmember support bolts | 180 | 133 | - | |
| Rear bumper beam to rail | 165 | 122 | - | |
| Rear tow hook bolts | 165 | 122 | - | |
| Rear tow hook support bracket bolt | 100 | 74 | - | |
| Trailer hitch bolts | 165 | 122 | - | |
| Transfer case skid plate bolts | 55 | 40 | - | |
| Transmission crossmember reinforcement bracket bolts | 48 | 35 | - | |
| Transmission crossmember to frame bolts | 55 | 40 | - | |
| Transmission crossmember to transmission mount bolts | 61 | 45 | - | |
| Transmission skid plate bolts | 25 | 18 | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.