Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024DURANGO SRT HELLCAT PLUSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, PARK ASSIST (PAM)INSTALLATION
2024 Dodge and Ram Durango SRT Hellcat Plus
Module, Park Assist (PAM): Installation
2024 Dodge and Ram Durango SRT Hellcat PlusSECTION Installation
- Position the Park Assist Module (PAM) (4) to the right lower inner D-pillar (2).
- Engage the mounting tabs on the bottom of the PAM into the two slots in the inner D-pillar.
- Install the fastener (1) that secures the mounting tab at the top of the PAM to the inner D-pillar.
- Connect the wire harness connectors (3) to the PAM connector receptacles. Vehicles with the front park assist option will have an additional connection to the PAM at this location, which must also be connected.
- Install the trim onto the right quarter inner panel. Refer to PANEL, QUARTER TRIM, INSTALLATION .
- Connect the negative cable to the battery.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.