Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024DURANGO SRT HELLCAT PLUSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSACTIVE CRUISE CONTROL (ACC) MODULE - DTCS B222F-00 TO U0101-00
2024 Dodge and Ram Durango SRT Hellcat Plus
Active Cruise Control (Acc) Module - DTCS B222F-00 To U0101-00
2024 Dodge and Ram Durango SRT Hellcat PlusSECTION Active Cruise Control (Acc) Module - DTCS B222F-00 To U0101-00
- DTC Troubleshooting
- B222F-00-Flash Write Performance
- C0063-9A-Yaw Rate Sensor - Component Or System Operating Conditions
- C008E-00-Ecu Internal Performance
- C1240-00-Steering Angle Sensor Angle OVERTRAVEL Performance
- C127A-00-Esp Did Not Respond To Deceleration Request
- C14A3-00-XBW Rule Violation
- C14A4-00-Sensor Adjustment Required
- C14A5-00-Sensor Blinded
- C14A6-92-Vehicle Reaction-Performance Or Incorrect Operation
- C15D8-00-Mismatch Tire Size
- C15DC-2A-Forward Collision Warning Control Switch-Stuck
- C2129-16-Battery Voltage - Circuit Voltage Below Threshold
- C2129-17-Battery Voltage - Circuit Voltage Above Threshold
- C212A-84-System Voltage - Signal Below Allowable Range
- C212A-85-System Voltage - Signal Above Allowable Range
- C2206-00-Vehicle Configuration Mismatch
- C2210-00-Ecu OVERTEMPERATURE
- C2212-00-Ecu In - Plant Mode Active
- C2223-00-Ecu Configuration Mismatch
- C2225-00-Pcm Disabled Ecu
- C2226-00-TCM Disabled Ecu
- C2227-00-Abs Disabled Ecu
- C2318-76-Front Camera - Wrong Mounting Position
- P0585-00 Speed Control Switch 1/2 Correlation
- P1593-2A-Speed Control Switch 1/2 Stuck
- P1666-00-Cruise Control Module Internal
- U0002-00-Can C Bus Off Performance
- U0009-00-High Speed Can Communication Bus (-) Shorted To Bus (+)
- U0100-00-Lost Communication With ECM/Pcm
- U0101-00-Lost Communication With TCM
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.