Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024DURANGO SRT HELLCAT PLUSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, SECURITY GATEWAY (SGW)INSTALLATION
2024 Dodge and Ram Durango SRT Hellcat Plus
Module, Security Gateway (SGW): Installation
2024 Dodge and Ram Durango SRT Hellcat PlusSECTION Installation
NOTE:
If a installing a NEW Security Gateway (SGW) Module, use the scan tool to configure/program the Module. Failure to configure/program the Module will leave the SGW Module in a locked mode, preventing proper SGW Module operation.
- Position the SGW Module to the bracket, then install and securely tighten the screws (1).
- Connect the SGW Module wiring harness connectors (1).
- Install and securely tighten the SGW Module bracket bolts (2).
- Connect the wiring harness connector, position passenger silencer panel (1) on instrument panel and install the fasteners.
- Install passenger side cowl panel. Refer to PANEL, COWL TRIM, SIDE, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
- If a NEW SGW Module is installed, use the scan tool to configure/program the SGW Module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.