Module, Radio Frequency (RF Hub): Installation

2024 Dodge and Ram Durango SRT Hellcat PlusSECTION Installation
NOTE:

Replace and Program the module(s) per the RF-Hub, BCM, PCM FOBIK and ELV Replacement and Programming Order Guide. Refer to STANDARD PROCEDURE .

  1. Position the Radio Frequency (RF Hub) Module to the vehicle, install and securely tighten the fasteners (2).
  2. If equipped, connect the remote start antenna wiring harness connector.
    GC0184538Courtesy of CHRYSLER GROUP, LLC
  3. Connect the RF-Hub Module wiring harness connectors (1).
  4. Install the left rear cargo interior trim panel. Refer to PANEL, QUARTER TRIM, INSTALLATION .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
NOTE:

Program the RF-Hub Module. Refer to MODULE, RADIO FREQUENCY (RF HUB), MODULE PROGRAMMING .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.