Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024DURANGO SRT HELLCAT PLUSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, FORWARD FACING CAMERA (FFCM)MODULE PROGRAMMING
2024 Dodge and Ram Durango SRT Hellcat Plus
Module Programming
2024 Dodge and Ram Durango SRT Hellcat PlusSECTION Module Programming
The Forward Facing Camera (FFC) calibration will need to be performed under the following conditions listed below:
- If the FFC and/or windshield has been removed or replaced.
- If the FFC module is removed from the bracket and then reinstalled.
- If the customer brings in a vehicle with Lane Departure Warning (LDW) system behavior concerns.
Perform the following steps to calibrate the FFC:
- Connect the diagnostic scan tool and start the vehicle.
- Navigate to the "Misc Functions" menu under the FFC and select the drive calibration routine.
- The screen will now prompt you to drive the vehicle for calibration. The vehicle needs to be driven at speeds of at least 40 km/h (25 mph) but no more than 119 km/h (74 mph) and in the straightest road condition possible. You need a lane with lines (dashed or solid) on both sides of the vehicle. This averages to roughly ten minutes of drive time, terrain permitting.
- After the camera learns the calibration, the scan tool FFC view will show calibrated.
- Service calibration Diagnostic Trouble Codes (DTC) should be in the stored status at this point.
- Erase the FFC DTCs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.