Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024DURANGO SRT HELLCAT PLUSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESBODY CONTROL MODULE (BCM) - DTCS U0213-00 TO U1433-24
2024 Dodge and Ram Durango SRT Hellcat Plus
Body Control Module (BCM) - DTCS U0213-00 To U1433-24
2024 Dodge and Ram Durango SRT Hellcat PlusSECTION Body Control Module (BCM) - DTCS U0213-00 To U1433-24
- DTC Troubleshooting
- U0213-00 Lost Communication With Interior Mirror Control Module "A"-
- U0231-00 Lost Communication With Light Rain Sensing Module
- U0232-00 Lost Communication With Blind Spot Detection Module
- U0241-00 Lost Communication With Auto HIGHBEAM Headlamp Control Module
- U0264-00 Lost Communication With Camera Module-Rear
- U1008-00 Lin 1 Bus
- U1009-00 Lin 2 Bus
- U1045-00 Lin 3 Bus
- U112D-00 Lost Communication With EVIC Steering Wheel Switches
- U113E-00 Lost Communication With Intelligent Battery Sensor
- U1190-00 Lost Communication With Humidity Sensor
- U11B9-00 Lost Communication With RF Hub
- U1215-00 Lost Communication With Forward Facing Camera
- U1223-00 Lost Communication With Wireless Charging Pad Module
- U1433-23 Implausible Ignition Switch Status Message Received-Signal Stuck Low
- U1433-24 Implausible Ignition Switch Status Message Received-Signal Stuck High
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.