Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2024DURANGO GT PLUS, AWDREPAIR AND DIAGNOSISELECTRICALBODY ELECTRICALPOWER DISTRIBUTIONMODULE, WIRELESS CHARGING PADINSTALLATION
2024 Dodge and Ram Durango GT Plus, AWD
Module, Wireless Charging Pad: Installation
2024 Dodge and Ram Durango GT Plus, AWDSECTION Installation
- Position the wireless charging pad module (2) to the bottom side of the wireless charging pad bracket (3).
- Install the fasteners (1) and tighten securely.
- Position the wireless charging pad bracket (2) to the floor console (3) and connect the wire harness connector.
- Install the wireless charging pad bracket (2) into the floor console (3). Verify the retaining clips are fully engaged.
- Install the fasteners (1) and tighten securely.
- Install the Shifter Bezel. Refer to BEZEL, SHIFTER, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
NOTE:
All vehicle doors need to be closed prior to testing the WCP operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.