Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM20241500 TRXREPAIR AND DIAGNOSISTRANSMISSIONTRANSFER CASEDRIVETRAIN CONTROL MODULE (DTCM) PART TIME - DTCS C147E-11 TO C2201-47 - 1500DTC TROUBLESHOOTINGC14AD-11 TRANSFER CASE RANGE POSITION SENSOR SUPPLY-CIRCUIT SHORT TO GROUNDWHEN MONITORED
2024 Dodge and Ram 1500 TRX
When Monitored
2024 Dodge and Ram 1500 TRXSECTION When Monitored
This diagnostic runs continuously when the following conditions are met:
- Ignition is in the RUN position.
- System voltage message received over Controller Area Network (CAN) is between 10-15 volts.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.