Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Connector Terminal Installation
2024 Dodge and Ram 1500 TRXSECTION Connector Terminal Installation
WARNING: This page is about a different car, the 2024 Jeep Wagoneer L, 2024 Jeep Wagoneer, 2024 Jeep Grand Wagoneer L, and 2024 Jeep Grand Wagoneer. However, it is still accessible from the selected car via links, so may be relevant.
- Select a wire from the terminal repair kit that best matches the color and gauge of the wire being repaired.
- Cut the repair wire to the proper length and remove one-half (1/2) inch of insulation.
- Splice the repair wire to the wire harness (see WIRE SPLICING procedure).
- Insert the repaired wire into the connector.
- Install the connector locking wedge, if required, and reconnect the connector to its mating half/component.
- Re-tape the wire harness starting at 1-1/2 inches behind the connector and 2 inches past the repair.
- Connect the battery and test all affected systems.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.