Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Module, Security Gateway (SGW): Description
The Security Gateway (SGW) is located behind the radio
Refer to RADIO, REMOVAL .
The SGW is a security hardware device to stop unwanted access and threats to the Controller Area Network (CAN) for the vehicle. The SGW does not contain any drivers and therefore does not directly operate or control any vehicle components.
The complexity of in-vehicle networking has led to the development of a variety of bus standards and protocols that are specific to their communication domains. The SGW serves as the information bridge between these communication domains and the diagnostic scan tool and the radio. Hardware security features of the SGW are used to prevent unauthorized bus network access.
The SGW is flash programmable. Failure to flash a newly installed SGW will leave it in a locked mode. When in the locked mode, the SGW will not operate.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.