Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Module, Keyless Ignition Node (Kin): Installation
2024 Dodge and Ram 1500 TRXSECTION Installation
WARNING: This page is about a different car, the 2023 RAM 1500 Classic. However, it is still accessible from the selected car via links, so may be relevant.
- Position the ignition to the vehicle for installation.
- Secure the ignition switch to the vehicle using four screws.
- Connect the wiring harness connector to the back of the ignition.
- Install the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, INSTALLATION .
- Connect the negative battery cable.
- Perform the Radio Frequency Hub (RF Hub) Module verification test. Refer to RADIO FREQUENCY HUB (RF HUB) VERIFICATION TEST .
- Program the Fobiks. Refer to MODULE, RADIO FREQUENCY (RF HUB), MODULE PROGRAMMING .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.