Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM20241500 TRXREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 26 (ELECTRONIC CONTROL MODULES (SERVICE INFORMATION) - 1500 CLASSIC)MODULE, HVACINSTALLATION
2024 Dodge and Ram 1500 TRX
Module, HVAC: Installation
2024 Dodge and Ram 1500 TRXSECTION Installation
WARNING: This page is about a different car, the 2023 RAM 1500 Classic. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the wire harness connector to the Heating, Ventilation, and Air Conditioning (HVAC) module.
- Position the HVAC module to the instrument panel, through the glove box opening and engage the module retaining screws to the slots on instrument panel.
- Tighten the two screws (1) that secure the HVAC module (2) to the instrument panel to 2 N.m (17 in. lbs.).
- Install the glove box. Refer to GLOVE BOX, INSTRUMENT PANEL, INSTALLATION .
- Install the right side instrument panel end cap.
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
- Initiate the Actuator Calibration function using a scan tool. Refer to HVAC VERIFICATION TEST .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.