Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Module, Door (DDM/PDM): Installation
2024 Dodge and Ram 1500 TRXSECTION Installation
WARNING: This page is about a different car, the 2023 RAM 1500 Classic. However, it is still accessible from the selected car via links, so may be relevant.
- Position the door control module (1) to the front door hardware module carrier.
- Install and tighten the two screws that secure the door control module to the front door hardware module carrier. Tighten the screws securely.
- Reconnect each of the electrical connectors to the connector receptacles of the door control module.
- Reinstall the trim panel to the inside of the front door. Refer to PANEL, DOOR TRIM, INSTALLATION .
- Reconnect the battery negative cable.
- The Manual Relearn procedure should be performed following service of a door control module so that the module can learn the correct hard stops of the power window regulator. Refer to DOOR MODULE LEARN PROCEDURES .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.